Victron Smart BMS CL 12-100 Interface cable for battery management system
Our service
Our Customer Service
Mon - Fri: 9am - 4pm
WE'RE THERE FOR YOU
Contact FormSend us your question regarding this product!
Secure payment with SSL encryption
Free Returns
Product description
Cable for Smart BMS CL 12-100 on MultiPlus
This cable allows the MultiPlus 500 VA - 1600 VA, MultiPlus Compact 800 VA - 2 kVA and MultiPlusII models to be used with BMS products that do not have a VE.Bus interface, such as the Smart BMS CL 12-100 and the miniBMS. These MultiPlus models can be controlled via the load/load break outputs or load/charger outputs
The wire must be wired to the remote on/off connector on the MultiPlus models
- When used with MultiPlus 500 VA-1200 VA models, connect the black wire to the AN terminal and the red wire to the (+) terminal
- When used with MultiPlus Compact 800 VA-2 kVA models, connect the black wire to the center terminal and the red wire to the right (IN) terminal
- When used with the MultiPlus II models, connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal
Both the load/charger disconnect outputs of the CL 12-100 Smart BMS and the load/charger outputs of the miniBMS must be in the 'High' state for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then turn on and begin charging (if connected to an AC power source).
This cable allows the MultiPlus 500 VA - 1600 VA, MultiPlus Compact 800 VA - 2 kVA and MultiPlusII models to be used with BMS products that do not have a VE.Bus interface, such as the Smart BMS CL 12-100 and the miniBMS. These MultiPlus models can be controlled via the load/load break outputs or load/charger outputs
The wire must be wired to the remote on/off connector on the MultiPlus models
- When used with MultiPlus 500 VA-1200 VA models, connect the black wire to the AN terminal and the red wire to the (+) terminal
- When used with MultiPlus Compact 800 VA-2 kVA models, connect the black wire to the center terminal and the red wire to the right (IN) terminal
- When used with the MultiPlus II models, connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal
Both the load/charger disconnect outputs of the CL 12-100 Smart BMS and the load/charger outputs of the miniBMS must be in the 'High' state for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then turn on and begin charging (if connected to an AC power source).
Features
| Type of solar panel | Solar accessories |
| Colour | black |
| Dimensions (LxWxH) | x 0 x 0 cm |
Our service
Our Customer Service
Mon - Fri: 9am - 4pm
WE'RE THERE FOR YOU
Contact FormSend us your question regarding this product!
Secure payment with SSL encryption
Free Returns
