Hindermann Wintertime compact motorhome protective cover

The Wintertime series of Hindermann protective covers are made of a breathable, 3-layer SFS-3 NONWOVEN material and are characterised by good tear resistance and low weight. The material used is a full-surface, breathable membrane whose basic structure is not comparable to that of a conventional film or fabric-reinforced material. Weather and external influences will affect the protective cover over the years. However, as long as the vehicle, rubber seals, upholstery etc. are protected, the function is fulfilled. The use of the cover is therefore the equivalent of cheaper than housing the vehicle in a shelter.

Each protective cover has 4 zippers which (when open) make it easier to put on and take off and allow access to the entrance door or storage compartments on both sides of the vehicle.
All protective covers have an eyelet strip on both sides as well as clamping straps on the front and rear sides.

The tensioning material is included in the standard scope of delivery, also a generously sized storage bag, including repair kit.

Article no	Length below	Length above	largest circumference	Unbelted belts	Width	Height
334540	630 cm	557 cm	17,10 m	7	225 cm	250 cm
334740	680 cm	607 cm	18,10 m	8	225 cm	250 cm
334750	730 cm	657 cm	19,10 m	8	225cm	250 cm

8 cross belts are included in the scope of delivery for all variants


Hint:
The height of the hood is always approx. 35 cm less than the total vehicle height. Allow for all protrusions such as the bicycle rack. Minor dimensional tolerances reserved.