Water Distributors
Water Distributors create clean, reliable splits in your caravan or motorhome water supply. With the right manifolds, push-fit connectors and isolation valves, you can route fresh water efficiently to kitchen, bathroom and outdoor showers while keeping maintenance simple and leaks at bay.
Read more about Water Distributors ...
Water Distributors
A dependable water distributor is the heart of a tidy fresh-water layout. It splits flow to taps and appliances, reduces pressure loss and makes servicing easier. Choose food-grade materials, compatible diameters and quality seals to keep water clean, quiet and leak-free at every pitch.
Caravan And Motorhome Water Distributors Basics
Start by sizing the distributor to match your pump output and typical demand. Multi-way manifolds with 2–6 outlets cover most layouts. Keep pipe diameters consistent where possible and plan short, direct runs to minimise pressure drops and noise.
Fresh-Water Distributor Placement
Mount the manifold centrally, close to the pump and tank for even flow. Leave space for tools and add a drip tray or absorbent mat to spot early leaks during checks.
Choosing Materials For Water Distributors
Food-grade plastics are lightweight and corrosion-free, while brass is rugged for high-stress locations. Always verify compatibility with disinfectants and winterising agents.
Fresh Water Distributors And Manifolds
Use straight, elbow and tee connecting pieces to keep runs neat. Colour-coded hot and cold lines simplify troubleshooting and upgrades. Where appliances need different sizes, use smooth-bore reducers to protect flow.
Outlet Management On Water Distributors
Blank unused ports with the caps supplied. Label each branch to kitchen, washroom and external shower to speed up servicing and seasonal checks.
Noise Reduction In Water Distribution
Add cushioned clips every 30–50 cm and anti-vibration mounts near the pump. Gentle bends reduce hammering and keep flow steady.
Push-Fit Water Distributor Connections
Push-fit couplers make assembly fast and reliable. Deburr pipe ends, mark insertion depth and push fully home for a leak-tight seal. For flexible hose transitions, use dedicated OD/ID adapters and quality clamps.
BSP Threads And Sealing On Water Distributors
Many taps, filters and inlets use BSP threads. Confirm male/female orientation and seal with the specified gasket or PTFE tape without overtightening to protect O-rings.
Quick-Connects For Water Distributors
Quick-connect sets speed up appliance swaps and winterising. Colour-matched pairs help you trace hot and cold lines at a glance.
Water Distributor Valves And Isolation
Fit mini ball valves on each outlet so you can service one branch without draining the whole system. Add a non-return valve near the pump to prevent backflow and pressure loss overnight.
Leak Prevention For Water Distributors
Pressure-test after changes, recheck after the first drive and replace tired O-rings. Keep spare caps, clamps and a universal coupler in your toolkit for quick fixes.
Frost Protection For Water Distributors
Place low-point drains on downstream lines and consider frost valves near heaters. Before storage, open all drains and set mixer taps to mid position so hot and cold circuits vent fully.
Winterising Checks On Water Distributors
Purge appliances per manufacturer guidance, disconnect portable hoses and cap external inlets to keep debris out over winter.
Waste Water Distributors And Routing
Grey-water distribution should maintain a gentle fall to the tank or drain. Use temperature-resistant pipe and angled connectors to avoid sags, gurgling and odours.
Odour Control In Water Distribution
Add traps close to sinks and keep vents clear. Periodic rinsing helps prevent residue build-up and keeps the system fresh.
Maintaining Your Water Distributor On The Road
Carry spare O-rings, thread gaskets and a short length of pipe. Regular cleaning and optional in-line filtration protect taste, pressure and component life season after season.
